Fixing unit (for both 115V and 230V, the only difference is the Halogen heater) (The fixing unit can be disassembled even after removing the Rear cover ASSY in section 1.6). (1) Release the hook of the heater lead wire connector (2P) by pinching the connector and pull it out upward (to remove it from the low-voltage power supply ASSY). (2) Pull out the Fixing PCB connector (4P) to the rear ( A ). (3) Loosen the 2 screws which are securing from the rear, and remove the fixing unit by pulling it to the rear.
Heater lead wire
A
Connector (2P) Connector (4P)
Screw Fixing unit
Screw
Figure 4.49 (4) Take off the Halogen heater by removing 2 screws at the both side, remove the Halogen heater.
Halogen heater Screw Fixing unit cover
Figure 4.50
Note:
Do not use the electric driver as the Halogen heater is easy to break. Do not touch the Halogen heater glass. If finger prints are on it, clean it with a cloth dampen with iPA alcohol. When reassembling, make sure; - The terminal of the heater lead wire connector (2P) should be placed over the terminal of the Halogen heater. - The wire bridge between the Halogen heater and its terminal must be up.
